Why does my LED light flicker? How to maintain lamps?


In normal life, I believe many people have encountered this situation. When the lamps at home are in use, they suddenly flash and flash, which makes people feel very scared. Then, the editor below will introduce the flashing of the lights. What’s going on in the blink of an eye, it’s necessary to find out together!

What’s the matter with the flashing lights

It may be that the wiring and the live wire are not connected firmly, which will increase the resistance of the wiring position, causing the voltage to sometimes be normal and sometimes abnormal, and then flash and flash. It may also be caused by insufficient power supply pressure in the power system, which cannot be solved by itself.

How to maintain the lamps:

  1. Early replacement of aging lamps:
    After the lamps in the home are used for a long time, the two sides of the lamp tubes will become red or black. In this case, they should be replaced immediately, mainly to prevent the ballast from burning out. Usually when you buy a lamp, the expiration date will be marked on the lamp, and replacing the lamp tube and bulb at home on time is very helpful for the protection of the entire lamp.
  2. The cleaning method should be correct:
    After the lamps are used for a long time, a thick layer of dust will accumulate in the bulbs, which affects people’s vision. Therefore, it is necessary to clean them on time. Then, when cleaning, pay attention not to change the structure of the lamps or change the position of the lamps casually. , After cleaning, you should install the lamp as it is, and do not install less or wrong screws.
    Generally, the lamps should be cleaned with a dry cloth, and pay attention to avoid the ingress of moisture. If the lamps are non-metallic, they can be cleaned with a damp cloth to prevent the accumulation of dust and dirt, which will affect the lighting effect.
  3. Frequent switching on and off of the most harmful lights:
    When the lamp is in use, it cannot be switched on all the time. When the lamp is often turned on, the current passing through the filament will be larger than the current in normal use, so that the temperature of the filament rises and sublimates immediately, thus greatly shortening the life of the lamp. , So it is necessary to reduce frequent switching as much as possible.

Summary: The above is the relevant content introduced by the editor about the flash and flash. I hope it can be helpful to everyone.

Share on facebook
Share on twitter
Share on linkedin

Leave a Reply

Your email address will not be published. Required fields are marked *

Send Us A Message

Please writing your email, we will reply within 8 hours.